Page 54 - RoboGenius Pro C5

STEP - 10 Drag the show number block and place it below on shake

the change steps by 1 block.
change steps by 1
STEP - 11 Drag the steps variable from the Variables show number steps
category and place it inside the show number

block.

This will display the total number of steps counted on the LED display.

Your block-based code will look like this.

STEP - 12 Click on the Shake button to run the program.

You can also download the code to your Micro:bit by clicking the Download button in

MakeCode then connect the Micro:bit to your computer and transfer the file.

Output

When the program runs, the Micro:bit starts counting steps using its accelerometer
sensor. Each time you shake or move the Micro:bit, the accelerometer detects

the motion and increases the step count by one. The total number of steps is then
displayed on the LED display using numbers.

RoboGenius Pro - V
52