Page 42 - Robo_Genius_V1.0_flipbook_C7
P. 42

Step 2  Wait for the confirmation

                              If the code is uploaded successfully, a message saying “Successfully Uploaded Sketch”
                              will appear in the status bar at the bottom of the screen.

                  Step 3  See the output
                                A few seconds after the upload is complete, you should see the output on your Tinker
                                Orbits kit! For example, if your code tells an LED light to turn on, it will light up on your
                                hardware.





















                  Blocks Used for Coding


                              CATEGORIES/BLOCKS                                      DESCRIPTION

                   Lights

                                                                    This pin is used to set the LED high/low.


                   Sensors
                                                                    It read the value from the LDR sensor.


                                                                    It read the value from the Soil moisture sensor.







                      40     RoboGenius (V1.0)-VII
   37   38   39   40   41   42   43   44   45   46   47